No subject

On Feb 22, 2011, at 1:29 PM, Mitch Barrie <mitch at mesatactical.com> wrote:

> On 2/22/2011 8:41 AM, Bruce A Bowling wrote:
> 
>> There is nothing wrong with using a GM TPI ECM with tuner tools - if the tools allow adjustment of the calibration parameters you require then it should work fine. There is no magic bullet here with MS or any other aftermarket controller.
> 
> Good.
> 
> I am compiling an overview or specification of this project, which I 
> will make available as a PDF to anyone who wants it.  What I am doing is 
> not nearly as esoteric as most of the projects I see discussed on this 
> list (basically, I am bolting a factory GM TPI set-up onto a ZZ4 crate 
> motor), but if anyone here is interested in this document, you are 
> welcome to it.
> 
> Right now it is in its very preliminary stages.
> 
> Thanks, everyone.
> 
> 
> Mitch
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi