Identity?

[Jon Fedock]

Thanks! That was what I was looking for :)
Jon

-----Original Message-----
From: Ludis Langens <ludis at cruzers.com>
To: gmecm at efi332.eng.ohio-state.edu <gmecm at efi332.eng.ohio-state.edu>
Date: Friday, April 16, 1999 1:12 AM
Subject: Re: Identity?


>Jon Fedock wrote:
>>
>> Thanks for the Info. But this leads me to another couple of questions.
What
>> is this out of? Where is the calibration stored (there isn't a prom)?
>>
>> >This sounds like the 16153597 ECM I have here.
>
>The 16153597 is from a Geo/Isuzu, this is/should be on my web xref.  It
>controls two sets of two Peak+Hold injectors.  The vehicle harness
>diagrams imply that this ECM could also drive two groups of saturated
>injectors.  The calibration is in EEPROM in the MPU chip.
>
>--
>Ludis Langens                               ludis (at) cruzers (dot) com
>Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
>