MAF/MAP

[Carl Summers]

Hi Mike,
      If you aren't doing trans shift control, I would use the 7730 for a
project....Universal harness' are inexpensive and the addresses for tuning
the prom are pretty well available.  The 7730 also has a decent ALDL
protocol speed compared to the 7747 tbi computer. hth's
-Carl Summers

-----Original Message-----
From: owner-gmecm at esl.eng.ohio-state.edu
[mailto:owner-gmecm at esl.eng.ohio-state.edu]On Behalf Of Mike Swayze
Sent: Tuesday, December 28, 1999 6:03 AM
To: GMECM_DIY_EFI
Subject: MAF/MAP


Being a newbie allows me to ask the dumb
questions...so what I was wondering
about concerns MAF and MAP vs MAP only
ecm's. Which of the ecm's that are MAF
and MAP have .bin's available that are
MAP only? I have noticed that some of
them are Australian versions
(808?/165?). I have been considering the
88-92 730/727 ecm's but am wondering if
there are others that I should be
considering also(batch fired port
injection).I guess what I am really
wondering
is if the TBI ecm's could be used for
port
injection(minus the MAF).
byE
Mike S.