Peak and Holds in a '165

[Mike Pitts]

You could easily build an external circuit to fire 'n' number
of your own drivers using the output signal of the driver in
the ECM.  Would probably cost you $50-$75 or so to make.
You could even get tricky and make it out of junkyard parts
so that it just plugs into the existing injector harness.

-----Original Message-----
From: Bruce Plecan <nacelp at bright.net>
To: gmecm at efi332.eng.ohio-state.edu <gmecm at efi332.eng.ohio-state.edu>
Date: Saturday, June 05, 1999 7:04 PM
Subject: Re: Peak and Holds in a '165


>The Peak+Hold option in the 165 is for a single injector, as in a 4 cyl TBI
>application, to the best of my knowledge.
>   The new Jeg's catalog shows an Accel injector controller (add one) that
>is used to tailor individual injjector timing, and says compatabile with
all
>injectors, only $400..
>Grumpy
>
>
>|     I have a plan (I know, I know...). I just got a set of low inpedance
>| 35lb injectors to go on a friend's aluminum-headed 383. My question is
>this:
>| Will the peak and hold driver in the '165 be able to handle 8 of these in
>| parallel provided I cut wire D15 (sensing resistor bypass) to use the
peak
>| and hold output? If it will not, does anyone have any leads on a stand
>alone
>| driver board to use to drive these injectors. Thanks for any help with
>this.
>| Jon Fedock
>
>