When asking ecm questions

[Frederic Breitwieser]

> I think Fred meant you have to move some wires in a FWD harness to use the
> GN code.  If you have a GN, you can use the FWD computer (same part number)
> with the GN code and not have to change the harness.  That is my
> understanding.  Am I correct?

Fred screwed up.  Fred mis-remembered facts.  I shall reiterate for
clarity.

1. FWD 148 into GN w/GN harness, sensors, etc.

Swap chip, works fine.

2. We messed with the wires because we had motor attached to dyno, not
car.  Certain things like tranny (electronic overdrive and speed sensor)
had to be simulated.

Sorry for the confusion folks :)


-- 

Frederic Breitwieser
Xephic Technology
769 Sylvan Ave #9
Bridgeport CT 06606

Tele: (203) 372-2707
 Fax: (603) 372-1147
Web: http://xephic.dynip.com/