manifold machining

[Frederic Breitwieser]

Loud thinking is always welcome :)

The intercooler is at the vertical center point just below the two throttle
bodies, which mount above the intercooler.  I didn't want to mount it too
low, because the plenum is an aerodynamically pathetic box, therefore
airflow at the corners of the box wouldn't be so good.  If I had the
intercooler mounted very low, I'd be using less surface area for cooling,
and the remainder of the unit wouldn't do much for cooling my intake charge.

That's the theory anyway.  I debated making it a little more aerodynamic,
but that didn't happen.  This is a remade intake from the first sheet metal
intake, which had two smaller plenums, about 150 cid each - with longer
runners, feeding the opposite side cylinders from which the turbo is being
powered from (kinda of a crisscross configuration, exhaust of one side blows
the other side)

-----Original Message-----
From: nacelp
To: gmecm at diy-efi.org
Sent: 4/7/00 3:15 PM
Subject: Re: manifold machining

If this is finned, and centered in the plenum, it might be effectively
reducing the plenum area to half, as far as the benefits of reversion,
waves
etc (for N/A cylinder filling conditions), since they are "hitting" it
at
less the min. resistance angles.
  Also, you'll need the lower area when under boost for the air to slow
down
enough to pass thru the finned area.  Then enough area again for the
cylinders to draw against.
  Just thinking out loud here
Grumpy



>  Aluminum transmission cooler
> brazed inside.
>
> -----Original Message-----
> From: nacelp
> To: gmecm at diy-efi.org
> Sent: 4/7/00 1:31 PM
> Subject: Re: manifold machining
>
> **WHAT?**.
> Fred:
> Is there a typo here?.
> You talking intake tract, or including runners, or what exactly for
> these
> numbers reflect?.
> Grumpy
>
> > My 451cid stroker mopar has a 1232 cid plenum,
> > and my 252cid Buick V6 has a 576 cid plenum.  Though, there is
nothing
> wrong
> > with mounting the throttle body right where the carb goes with an
> adaptor
> > plate, for a street car.  Racing is a different story.
> >
>
>
------------------------------------------------------------------------
> ----
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
> in the body of a message (not the subject) to
> majordomo at lists.diy-efi.org
>
------------------------------------------------------------------------
--
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
> in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
>

------------------------------------------------------------------------
----
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org