manifold machining

[Frederic Breitwieser]

> And there is no way Cornholio could drill straight enough to line up 2 lines
> of 4 bungholes in a straight line and correct angle... :-)

Use a stubby milling bit in our drill press, its doable.  I, the least
mechanically inclined individual around did it.

http://xephic.dynip.com/dodge/dodge.html

> I'm going in for some surgery tomorrow, but when I get back and Dave W. gets
> my intake(thanks again, Dave!), I'll be back looking for tips on getting a

Good luck on the surgery, and Dave can do this no problem.  Cool.

-- 

Frederic Breitwieser
Xephic Technology
769 Sylvan Ave #9
Bridgeport CT 06606

Tele: (203) 372-2707
 Fax: (603) 372-1147
Web: http://xephic.dynip.com/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org