B/L INT Numbers

[Roger Heflin]

On Fri, 14 Apr 2000, Marteney, Steven J. wrote:

> Ignore this post if I'm wrong, but...
> If you are looking at block learn's with a scanner, doesn't it ONLY display
> the current block learn mult or int?  But, block learn's are tabular in
> nature and the table is indexed by TPS and something else.  So, naturally,
> if TPS changes you'll see the BLM,BLI change because it jumped to a
> different spot in the table.  With constant TPS, the same table spot is used
> and will only change if ECM deems it necessary.  Am I all wet?  (or green?)
> 
> Steve

The table indexing is pretty crude, the table is 4x4 so you can have
quite a wide range of conditions in a single table entry.

And within a single table entry it may need to adjust quite a bit.

				Roger

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org