30# injectors

[Mark Romans (ICQ#66838770)]

730's are saturated type drivers, Ford 30#'s should be the same.
Mark
-----Original Message-----
From: Craig Marcho <marcho at flash.net>
To: gmecm at diy-efi.org <gmecm at diy-efi.org>
Date: Sunday, April 16, 2000 8:14 PM
Subject: RE: 30# injectors


>1) I don't know for sure.....
>2) Yes, I think even 24# would be enough for a 383.
>3) I've got 24# FMS injectors on my '85 TPI setup and they fit fine. If the
>30# are the same physical size, then they should work fine.
>
>
>> -----Original Message-----
>> From: owner-gmecm at diy-efi.org [mailto:owner-gmecm at diy-efi.org]On Behalf
>> Of Marc Piccioni
>> Sent: Thursday, April 16, 1998 10:05 PM
>> To: 'gmecm at diy-efi.org'
>> Subject: 30# injectors
>>
>>
>> I'd like to know if 30#/hr Ford Motorsport injectors are:
>>
>> 1) the right impedance for a '730.
>> 2) sufficient to feed a 383 ci (mild street motor).
>> 3) will physically fit a early TPI mainfold and fuel rails( the
>> base has the cold start injector).
>>
>> /Marc
>>
>>
>
>---------------------------------------------------------------------------
-
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org