Plug Reading

[Bruce Plecan]

Balancer issue?.
No hole torque
With hole higher rpm breathing, at expense of off idle (well low rpm) grunt.
Had ported twoo manifolds  and was doing back to back testing to make sure
my porting was even beftween the two.  I hadn't done a before test.
HAhahahaha,  boy did I fell stupud on that test drive.
Bruce


> Sounds like the balancer/non balancer hole issue with the Xfire manifold.
>
> Dominic
> ----- Original Message -----
> From: "Ernst denBroeder" <edenbroe at cisco.com>
> To: <gmecm at diy-efi.org>
> Sent: Wednesday, August 16, 2000 9:34 AM
> Subject: Re: Plug Reading
>
>
> >
> > >
> > > > Ohh the intake works so much better...thank you thank you...
> > >
> > >Welcome.
> >
> > Mike / Bruce,
> >
> > This mod, was that the suggestion of drilling some holes in the TPI base
> to
> > sorta siamese the runners?
> >
> > Just curious...
> >
> > Thanks,
> > Ernst
> >
> >
>
> --------------------------------------------------------------------------
> --
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
> >
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org