Ford injectors

[Dan Townsend]

The dark blue 30# svo injectors that I had did have the grooves and I got
them about a year ago.  I have ran the injectors without the retention clips
with no problems.  Just be careful when you put the rail back together not
to cut an o-ring like I did.  The o-rings I am talking about are part of the
rail assembly not the ones on the injectors.

Also the 30# will work with a stock chip on a stock engine but don't go WOT
:-)

From: "Dan Plaskett" <dynastydan at worldnet.att.net>
Subject: Re: Ford injectors


> Ditto on 30lb injectors on my 406 TPI 86 vette.  These did not have
grooves
> cut for the retention clips.  When first installed I had to work with them
> because when the fuel pump kicked on I had fuel everywhere.  Eventually
got
> them adjusted so I don't have fuel leaks but I've always been a little
> concerned that I might be pulling some vacuum from the bottom injector
seal
>
> Dan Plaskett
>
> ----- Original Message -----
> From: "Craig Marcho" <marcho at flash.net>
> To: <gmecm at diy-efi.org>
> Sent: Wednesday, August 16, 2000 7:26 PM
> Subject: RE: Ford injectors
>
>
> > I've put the 24lb Ford injectors on my '85 TPI 'Vette and they work
great.
> > They are shorter, but as you said, they do fit in the fuel rail enough.
> >
> > Craig M.

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org