1226519 ECM 160 baud ALDL output

[Ludis Langens]

Louis Baiani wrote:
> 
> I made an adapter to read the ALDL info from the 1226519 ECM (closed
> loop carburator control - CLCC) for an 84 Century.
> 
> The distributor was
> never isolated, so I unplugged the 4 terminal HEI connector to the
> computer.  I have found that this cured the problem, and the data is
> perfectly fine.

You aren't telling us much about your adapter.  Where does it get it's
power?  If the power comes from the car, how well is this filtered? 
What sort of signal level conversion do you do, if any?  Try running
your adapter (and your laptop or whatever) from a battery.

This carb ECM outputs the ALDL on the check engine light, correct?  You
might want to pull the bulb out because the other end of the bulb lives
on the noisy 12 volt vehicle power circuit.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org