EPROM identification

WEG1192 at aol.com WEG1192 at aol.com
Tue Dec 5 05:23:13 GMT 2000


Ok,  now that I know what EPROM I have, I choose National EPROM 27(C)256 (5V) 
32K x 8(?), and the burner says its programming, goes through counting up to 
7F00(?), and then says programming error after it appears to try and verify 
the burn. At this point, I'm looking at having to unsolder the EPROM and 
solder in another 27C256 that I have had success with. Is it possible that I 
fried the EPROM by changing the Vcc voltage higher and higher? The blank 
check comes back "erased" and the file can be read and edited although all 
bits are FF (erased).  Any prior and future help is greatly appreciated.   JW
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org




More information about the Gmecm mailing list