LM3914???

[Bob Valentine]

At 12:36 PM 2/7/00 -0500, you wrote:
>The only drawback to this module is that it has an on-chip 10/1 divider, so
>it reads 1.2V to 12V in... rather than 0-1V.  Good idea though.

I had wanted to gang 2 or more of the 3914's together, feed the O2 thru a
op-amp and then have a higher resolution scale.   I was never able to
figure out exactly how to do this... I'm more programmer than H/W guru.

Anyone ever do this?
 
>I made this and it works well, except I made eight on one board, using eight
>10-segment bar graph LEDs, allowing me/us to monitor Air/Fuel on each
>cylinder of an engine on a dyno.

I WW'd my own, sure looks nice hanging from the rear-view mirror.  


--> Bob Valentine
--> bob at tecmark.com

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org