Debugger board for P4 ECMs

[Ludis Langens]

Swayze wrote:
> 
> could this debugger be setup to go through an ECM checkout routine in
> order to verify whether an on the bench ECM is a 'good' unit or to
> locate a malfunctioning part of an ECM?

You don't really need an add-on board to do that, just a MEMCAL with
appropriate self test software.

The peripheral board would allow you to hook up a terminal emulator and
get a command line interface to the testing software though.  This would
let the software promt the user to perform various tests ("Ground pin
D10."  "Hook a test light to F1.")

> the RPN I'm guessing would be similar to an HP calculator with
> specific memory addresses to read. do you have this documented any
> where. I will be checking out the schematic later today.

RPN = Reverse Polish Notation, aka postfix notation

In RPN, to add three and four:  3 4 +

No documation.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org