PCM's measuring torque.

[Shannen Durphey]

It's done in pickups with E series transmissions.  I replaced a trans
in one a few years ago, and I don't think it was an OBD II vehicle. 
So 95 software may have the capability.   I think transmission input
shaft speed is also a factor, since I've never seen scantool torque
values on a manual trans application.
Shannen

Scot Sealander wrote:
> 
> Ross Myers wrote:
> 
> > How do PCM's measure (assume!) the Engine Torque values?. I have seen this
> > as a ScanTool parameter, what is the software procedure for this?
> 
> I have never seen that done in GM software (yet), but my guess is that
> it is closely related to fuel pulse width.
> 
> Scot Sealander
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org