Accel DFI help maybe?

[Chipsbyal at aol.com]

This system uses Calmap 5.0 software. It controls all of the fuel and WOT 
spark only. According to the manual, the processor takes over spark control 
at about 75% TPS, disregarding any knock sensor input. The spark control can 
be left as stock if desired. The map sensor can be configured as a 1,2 or 3 
bar. Open or closed loop enables, temp and rpm ranges can be defined. Nitrous 
oxide settings similar to the later DFI setups is there too. 
 If the engine is too radical from stock, a custom chip is necessary for idle 
speed control.
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org