95 S-blazer base timeing

[David Cooley]

At 01:03 PM 7/20/2000, you wrote:
>Hey does anybody know what the procedure on setting base timing on a 95
>S-Blazer 4.3L CPI Vortec is.  This is the underhood ecm with the OBDII
>(or partial OBDII?) setup.  Haven't been able to find a EST Bypass
>connector yet.


EST Bypass connector is under the carpet on the pass. side floorboard where 
the carpet goes and curves up over the firewall.
Single pin grey connector.


===========================================================
David Cooley N5XMT Internet: N5XMT at triad.rr.com
Packet: N5XMT at KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
I am Pentium of Borg... Division is Futile!
===========================================================

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org