Injector Duty cycle calculations

[timsiford at hushmail.com]

Roger:

>  I went from 22->30lb ones.

What is your current setup?  Did you notice any wierdities at idle with 
the bigger injectors?

>What rpm are you measuring on the 97?   

6350rpms, 10ms

> And what fuel pressure is he running? 

Don't know exactly.  But, I do know that its less than what I am running 
with the same injectors.

>  If that cam is a 224/236-114, it has run out of power a
>couple of hundred rpm before 6500.  

Its a 224/236 -112

>What were the O2 sensors reading in both above cases, 

860-880mV

Thanks for the help Roger.  I appreciate it!

Tim


IMPORTANT NOTICE:  If you are not using HushMail, this message could have been read easily by the many people who have access to your open personal email messages.
Get your FREE, totally secure email address at http://www.hushmail.com.



----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org