Len Sabatine optispark to sbc

[Len Sabatine]

  The machinist was me and in our shop. The "Block" needs cam thrust control
added , and it works the same as it did on the LT engine design. If there's 
interest
on your part about this subject , best contact me off list  as not to 
belabor the LIST
Server.  L8 ER
Len

>Len Sabatine, you mentioned you had done the custom cover for optispark to
>mate to standard sbc, do you have any information you can share on that
>conversion, or the machinist you used maybe willing to reproduce the part, or
>was it worth it, maybe i should just run a carb until i get my 4 layer board
>working.
>
>thanks to all for your thoughts on this one.  SKip
>----------------------------------------------------------------------------
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org