Considering Injector Change..

[ECMnut at aol.com]

>  I have seen other people do them without a board, omitting the zeners and
>  gooping the bias resistors and wiring flat across the motherboard with
>  potting compound.  I think the zeners are a good safety addition, and this
>  looked like more of a PITA to me than just mounting them on a small board.
>  You could also put the entire thing into a separate box outside the ECM and
>  wire it externally; that might be the neatest method.
>  
>  Anyway, that's about it; hope it helps!
>  Kendall Frederick

 I think you're right..  This is best left to someone who solders better 
than this hack.
I will take lots of digipics if I attempt this.
Thanks,
Mike
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org