tpi intakes

[Bruce Plecan]

> Are you talking about grinding a set of stock runners starting from the
end
> that meets the manifold?  Or, are you talking about grinding the manifold?

Manifold
Grumpy

> Or, are you specifically talking about modifying a set of siamesed
runners?
> Obviously, I'm confused.
>
> Steve
>
> -----Original Message-----
> From: Bruce Plecan [mailto:nacelp at bright.net]
> Sent: Tuesday, June 06, 2000 2:49 PM
> To: gmecm at diy-efi.org
> Subject: Re: tpi intakes
>
>
>
> Accel Super Ram (?) is  the only real way to do it, TPS has the mini ram,
> but some guys have had to do lots of work to install them.
>    Even if you get the runners right, the plenum is fighting you.
> What I think **MIGHT** work is down by the head side of the intake
manifold
> grind a 1" hole 3"s up them the end of the runner, For the siamesed
runners.
> That way you have the volume of two tunners to draw against to the runner
> lenght of what a single plane manifold would offer.  If ya get what I
mean.
> grumpy
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org