How to do 165 to 730

[Mike Rolica]

Oh ya  that the other thing <grin>  took it for granted you new that....
Need the 730 connectors too.... The pins fit in the little holes the same...
I just switched one pin at a time..... even better to draw diagram first to
plan on which ones to switch.. takes about 30min if your patient....oh..
check and recheck them... several times..
Mike Rolica
Plant A,
Magnesium Products Division
Strathroy

(519)-245-4040  Ext. 265


	-----Original Message-----
	From:	Bruce Plecan [SMTP:nacelp at bright.net]
	Sent:	Friday, June 23, 2000 8:05 AM
	To:	gmecm at diy-efi.org
	Subject:	Re: How to do 165 to 730




	> I thought the 165 and 730 connectors were the same except for the
location
	> of about 12 pins?

	If you go to the FTP you can down load the ecm pinouts, and see the
	differences, and no the 730 uses 3 connectors, the 165 and 870 use
just 2

	  You used the MAF wires for the MAP right?  Beats adding
	> more wire.  Sounds like alot of work to switch ECM connectors.

	Not if your methodical.
	Easy to give up before starting
	Grumpy

	> Jim Brady
	> '87 Monte SS 383 TPI 6 speed


	
----------------------------------------------------------------------------
	To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
	in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org