TBI SPACER ?

[Mike Rolica]

It is on the inside of the truck under dash on the pasenger side, by the
heater... ha same problem too <G>
Mike Rolica
Plant A,
Magnesium Products Division
Strathroy

(519)-245-4040  Ext. 265


	-----Original Message-----
	From:	Todd Burkard [SMTP:toddburkard at pcmc.com]
	Sent:	Tuesday, June 27, 2000 11:59 AM
	To:	<
	Subject:	TBI SPACER ?

	I put a Spacer under my TBI on my 94 GMC K1500 the other day and now
I get a hesitation when I mat the Gas to the floor any Ideas? I was going to
look at the timing to make sure it was set correctly to start with because I
never looked at it from the day I bout the truck and I can't find that
little Tan wire you disconnect for setting the timing. I found it on the 88
I used to have and it isn't in that spot. Any ideas where they hide it now?
Another thought I had was maybe a clogged fuel filter (90000 on the original
one) ? Would a bad U-joint possibly cause enough bindage?

	Things I have looked for was vacuum leeks and I also have ran a tank
of injector cleaner through and also sprayed it out with Throttle body
cleaner. At first I thought the Tranny was slipping but I watch the tach and
it didn't go up till the tires started to squeal. I put new plugs in last
summer when I put the headers on and it had a new cap, rotor, and plug wires
put on 30000 miles ago, haven't pulled the cap off to check for corrosion or
cracks though.

	Thanks,
	Todd

	
----------------------------------------------------------------------------
	To unsubscribe from gmecm, send "unsubscribe gmecm" (without the
quotes)
	in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org