MAP signal damping/more cam help

[JTesta1966 at aol.com]

In a message dated 3/13/00 9:43:49 AM Eastern Standard Time, 
tystorm at email.msn.com writes:

<< hat allows the rings to break-in properly and as fast as safely possible as
 the best choice.  I know that a few here on this list have said that GM
 programming is at times a bit lame (I can also attest to that ;-) and we
 enjoy making it better, same for after one of us spends 2 to 5 grand for a
 good performance rebuild (or more), that we want what is best for our engine
 and respect following a sensible break-in approach.  There can be no
 arguing that new rings generate a bit of friction at first start up and
 until they finally  >>

I dont recall on which ECM's, but MOST if you scan them theres an "E-Cell 
Expired" parameter, which was for breakin. I dont know what parameters were 
different, but if you can find in the rom code (or wherever it might have 
been) what was mod'd you could possible burn a "break in" chip?

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Jim Testa                                         TType86 on #BuickGN
jtesta1966 at aol.com                               buick.fiendish.net:6667
ASE Master Technician            NJ Lic. Motor Vehicle Inspector
L1 Adv Eng Perf Certified     NJ Licensed Emissions repair Tech
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org