TPI 747

[nacelp]

Since your running a TBI might just use a 749 wired up as the Sunbird
version, which uses P+H, the info is out on the VSS stuff.   Then use a 730
or 749 memcal (just need right cyl count).  Ludis has done all the work for
ID'ing the cross overs in the I/O stuff so using either prom editor should
make it easier.
Grumpy
   Of course like Ward said, P6 would be nice....


> This is so true (lack of room). I'm using the 747 as I started before the
> hac's became available. At the time, there was some decent info on the
> 747, which made it attractive.
>
> I've added patches, along with looking at increasing table sizes. In order
> to do a lot of this, I'd like to disable the on-board ROM, add decoding,
> then a larger EPROM. It's getting where I'm weighing the cost of going to
> a 730, against the investment I have in the 747.
>
> No matter, as I am frantically working on the fuel delivery system for the
> TBI. I need to get it running to do a school paper (need the credits).
>
> BobR.
>
> nacelp wrote:
>
> > More a lack of room to tinker with things.
> > While it's OK and then some, it's just not perfect, and he's gone over
> > everything trying to get it that way.  Like I said he's fussy, and that
> > means time, so at some point it would habe been just easier, and faster
to
> > use say a 730, is all..
> > Grumpy
> >
> > > Yea, the biggest problem with the '747 is lack of data. The aldl sends
a
> > small
> > > frame of data once every two seconds or so. Do you think that may be
why
> > he
> > > does not like doing this conversion? (A simple board with a handful of
> > chips,
> > > and all 256 bytes of scratch-pad ram are yours up to 36 times a
second.)
> > >
> > > BobR.
> > >
> > > nacelp wrote:
> > >
> > > > Just a note.
> > > > A friend that does calibrations at the oem level, has just finished
> > doing a
> > > > SBC TPI run by a 747.  While it runs OK, and the owner is happy, he
says
> > > > that's the last one he'll ever do.  No specifics yet, but he
definetly
> > knows
> > > > his stuff.  Just not as good as a 730 system is, in drivibility,
course
> > he's
> > > > the fussy type.
> > > > Grumpy
> > > >
> > >
> >
> --------------------------------------------------------------------------
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org