Driving an HEI Module with other signals

[nacelp]

The voltage drop across a LED is enough to trigger it, soooo.  Any circuit
that you can make a LED flicker, is good enough to use where the pickup coil
would wire to the module.  Howz that for none-EE terms,,,,
Grumpy
    But is polarity sensitive
    GN is due back shortly!!
    The lowest backpressure mufflers in the world have to be the ATR
Pitbulls.  (864) 972-3800.  Using them (1)  3", on the SBC Regal.  It's a
straight thru, yikes, everyone will know when it's on the road <G>..


> I'm wondering if it's possible to drive an HEI (High Energy
> Ignition) module with other than a reluctor pickup coil.
> The HEI module I'm thinking of has three groups of connectors:
>
>  1. (+) to battery
>     (C) to Coil
>
>  2. (G) Ground
>     (B) Bypass control
>     (R) Reference to ECU
>     (E) EST (Timing from ECU)
>
>  3. (P) \_ to reluctor coil
>     (N) /
>
> I'm wondering if it could be made to work with an existing
> mechanical points, and an interface/translator circuit.
> Or, perhaps made to work with a hall effect/optical sensor?
>
> Thank in advance.
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org