V6 ALDL Communications

[Ludis Langens]

Jeremy Gonyou wrote:
> 
> Got a new cable (thanks again Andrew) with dip switches for various
> resitor values across A and B.  Looking at my code, I'm fairly certain that
> the car is looking for a 3.9 k resistor.  However when I set my cable to
> such the car goes beserk!  3000 rpm idle.  Codes 33 and 35, and still no
> data.  The car will barely run with this resitor!

3.9K ohms selects the limp-home test mode.  If you want to communicate
with the ECM, use 10K ohms instead.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org