GM 4 cylinder DIS

[Jurgen Hartwig]

>For all the work to do that it would be alot easier in my book to >just do 
>the ecm work, for ignition control.
>If you look at some of the timing maps (yes you'd have to download >the zip 
>archives and hunt), but you'll see that it would take a TON >of work to get 
>the same curves with anything else.
>

Alright, thanks for the reply.  Another fellow has already done the setup 
with the microcontroller, and I was hesitant, knowing that the work was 
already in the ECM.  I downloaded the archives last week and am a quarter 
way through them.

>Slightly over a hundred, and with shopping right at.
>Get a Needhams's and be done with it.  You probably could get most >of you 
>money back out of it from someone on the list if you quit.
>

Whoa!  I think I was missing something, but last week I thought the talk was 
several hundred dollars for equipment.  I don't have the emails in front of 
me now.  If it will only cost me a hundred or two, then I'm all for it.  A 
microcontroller on a board is already going to costs me $75 or more and I 
still have to program it.  Again, I will check the archives and do more 
research.  At least with the ECM, I would potentially have the option of 
going to FI when I felt comfortable with what I am doing.



>You can do, just an ignition only ecm.   Then add the Fuel to it later
>Grumpy
>
>Hold off doing anything till your really sure of what you want to do.


Thanks again.  I need to do some homework before I come back here again.  
This sounds very promising.

Jay
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org