7749 ECU PW musings.....

[ECMnut at aol.com]

Oh man, that would be a good spec sheet.
I just know as soon as I see the speed comparisons between low inpedence
and high impedence injectors, I'll have "pintle envy" for them low-imps...
MV

> This may be nothing.. but is there a published pintle speed, or amount of
>  time from OPEN to CLOSE and vise versa, flow characteristic (curve) for
>  varying pintle positions (10,20,30,.. %) for a given injector?  What I'm
>  getting at.. If the amount of time that the injector is to be CLOSED is 
less
>  than the amount of time it actually takes the pintle TO close, then you 
wont
>  get a CLICK noise as it closes.. it will start opening again.  "pintle
>  float" ??
>  
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org