Fuel Injector Connector - *the MALE side* ?

[Garfield Willis]

On Thu, 18 May 2000 22:33:09 -0400, "nacelp" <nacelp at bright.net> wrote:

>Anywhoz,  the clip to hold the injector onto the fuel rail, and the
>"snap" ring for holding the electrical connections on are for assembly line
>abuse, to keep things together as the UAW workers assemble things.
>  How this would apply to avio use I wouldn't venture a guess.  Solid
>mounted engine and lots of vibration might be a different deal all together,
>but then if that bad, I'd be soldering heat shrinking things together.
>  And to answer your actual guestion, been to several county fairs, and
>never saw em.....

Hee, dang I was hoping you HAD seen sumpin at the fair. Durn.

Seriously, I sure admire/appreciate the progress we've made with O-ring
connections and individual injector fuel-rail clips on the fluid/fuel
side. Sure makes custom fuel plumbing easier. Unfortunately, if you're
planning on inserting some trick electrics between the ECU and the
injector, you want something that's hard to wiggle loose there too. This
is an automotive app we're thinking of (shhh), not an aviation thingie,
so I'm still interested in what the UAW would do. :)

Interestingly enough, didyaknow that solder connections are
largely/actually a no-no in aviation/aerospace? What they've found thru
experience (read: crashes/failures) is that if the connection is secured
physically solid via solder connections, then at the point the solder
stops and the stranded wire begins, IF you haven't strain-relieved the
wire at that point, vibration causes the wire to break off THERE, and
not the soldered connection!

Trouble is, when you solder a connection, the solder wicks up some and
THERE is where the flexing happens, so if you just leave the connection
secured by solder, and don't strain-relieve the exiting wire, the solder
connection is fine, but the connection still breaks if vibrated. Many of
the more "emphatic" crimp connections are actually gas-tight, so what
turns out a more reliable connection is indeed crimp connection, with
strain-relief/crimp-hold on the trailing/exiting insulated wire. Hard to
believe maybe, but properly crimped spade terminals with strain relief
are really pretty good, not to mention things like Metripack and
Weatherpack connections; they're just about as good as it gets! Golly.

Solder AND strain-relief with some robust shrink or sleeving would
probly be the best, but it's not much better than a properly crimped and
finished connector, either. We use both, depending on app.

Gar


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org