cts

[nacelp]

I once had to make 1"  spacer the shape of the thermostat housing gasket,
and then tap it for the sensor.  I needs to be exposed to the actual in
block coolant temp., too much wagging around, and then too cool when heater
on in some applications
Grumpy




> I am adapting a 1227747 to fit onto a jeep 258.  My question regards the
mounting of the coolant temp sensor.  For simplicity, I can't mount the cts
in the engine block or the manifold (it's unheated).  I was wondering if I
could mount it in the thermostat housing.
> I realize that during start up that the temperature in the block vs the
housing would be different due to the closed thermostat.  I don't know the
magnitude of the difference though.  Would just mounting it in the
thermostat housing be good enough?
>
> Any opinions?
>
> Thanks,
> Omer Ozkul
> obond at mit.edu
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org