Injector driver

[Ludis Langens]

KasaRyan at aol.com wrote:
> 
> 6-I'm open to suggestions and would like to know if the prom really needs to
> be removed from the 93&up carrier thingie to be read/programmed.  seems like
> you could just connect the reader wires to the IDE-like connector on the
> bottom of it.

Yup, there is no need to remove the chip from the carrier.  You just
need to build an adapter between the plug on the carrier and your PROM burner.

You might run into some trouble fitting the carrier with chip into the
EPROM eraser though.  This just means that you need to modify your eraser.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org