7747 spark control questions.

[Shannen Durphey]

Depends on reference or initial timing value at 0x009.  If bias is at
10 Dizz base at 9, and static angle is 9, spark table is only 10 deg
biased.
Shannen

Programmer wrote:
> 
> You're at 9 BTC with the EST disconnected ? That adds another 10 with
> EST connected. You're going to be close to 35-40 BTC hot idle.
> Lyndon.
> -----Original Message-----
> From: Reid Bishop <rbish at ibm.net>
> To: gmecm at diy-efi.org <gmecm at diy-efi.org>
> Date: October 17, 2000 12:52 AM
> Subject: RE: 7747 spark control questions.
> 
> >>>Dissies are set "0" with the EST disconnected. The bins should show main
> >>>spark bias at 10 degrees.
> >
> >Really?  Hmmmm... my 4.3 dist is set to 9 BTC, and I my spark bias is set
> to
> >10.  I could still use more advance throughout the curve, but not working
> >that yet.
> >
> >Are 4.3's the exception to this rule?
> >
> >---------------------------------------------------------------------------
> -
> >To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> >in the body of a message (not the subject) to majordomo at lists.diy-efi.org
> >
> 
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org