LT-1 Heads

[Romans, Mark]

L98's are standard flow
LT1's are reverse flow
LS1's are standard flow.
L98 and LT1's shares some bottom end components.
LS1's share no components with prior smalll blocks.
Mark
----- Original Message -----
From: "Gabe" <gellett at earthlink.net>
To: <gmecm at diy-efi.org>
Sent: Monday, September 04, 2000 4:57 PM
Subject: Re: LT-1 Heads


> The LS-1 is a completely new design engine, where the LT-1 still had the
old
> small block rotating assembly.  If I remember correctly the LS-1 heads
have the
> Ford 4 bolt per cyl setup instead of the 5 like the older heads....
>
> Gabe
>
> WEG1192 at aol.com wrote:
>
> > Ok, what's the difference between the LT-1 and the LS-1? I thought the
LS-1
> > was the start of reverse flow cooling? Just trying to educate myself on
the
> > later engines.
>
> --------------------------------------------------------------------------
--
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org