knock sensor installation

[Programmer]

Try one of the engine block coolant drains.
Lyndon.
-----Original Message-----
From: s. douglas taylor <x5gb7uk9 at wna-linknet.com>
To: gmecm at diy-efi.org <gmecm at diy-efi.org>
Date: September 14, 2000 8:41 PM
Subject: Re: knock sensor installation


>i am ready to install my tbi conversion on my early sbc. my question is
>where/how is the best way the install the knock sensor? all my stuff came
>off an 89 s15 jimmy. on this truck screwed into a hole on the bellhousing
>flange. should i drill and tap a hole on my engine? i can do it, but hope
>there's an easier way.
>tia
>ciao...douglas
>
>---------------------------------------------------------------------------
-
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org