switches

[ae2598 at wayne.edu]

Prox switches might be the best bet.. Position them so they can see the
shifter in its various positions.  Assuming of course, that the shifter is
made of an iron alloy!

 On Thu, 16 Aug 2001, Shannen Durphey wrote:

> Best thing I can think of is to make something which goes on the trans end of
> the shifter cable.  Micro switches or push buttons should work.  Or maybe you
> could build a simple optical unit to go under the center console?
> 
> Shannen
> 
> sapearso at rockwellcollins.com wrote:
> > 
> > Has anyone seen a factory application that has sensors or switches to
> > identify what gear a manual transmission is in?
> > 
> > Scott
> > 
> > ----------------------------------------------------------------------------
> > To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> > in the body of a message (not the subject) to majordomo at lists.diy-efi.org
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
> 
> 


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org