off topic, h*lp

[Programmer]

The only time I've seen this with no actual "codes" is
when the MAF gets slewed. If some PFI cleaner in the
tank doesn't change anything--get someone with a
TECH2 to check it out...check "pending" codes.

Lyndon
----- Original Message -----
From: steve ravet <sravet at arm.com>
To: <gmecm at diy-efi.org>
Sent: August 25, 2001 8:56 AM
Subject: off topic, h*lp


> I need some advice...  Our suburban (2001) has developed a bad knock,
> due to a bad tank of gas I think.  I was going to run some GM top engine
> cleaner thru it but if I open the ductwork before the throttle body the
> engine dies.  This engine is throttle by wire (!?) so pressing the gas
> pedal is of no use trying to keep it going.  Any suggestions on how to
> keep it running long enough to pour a bottle of TEC?  This stuff has to
> go thru the throttle, you can't put it in the gas tank.
>
> Take it to the dealer since it's under warranty you say?  According to
> the dealer this is normal, no fix required.
>
> --steve
>
> --
> Steve Ravet
> steve.ravet at arm.com
> ARM,Inc.
> www.arm.com
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org