DIY WB on EEC list

[Tyler Townsley]

I am the party that cross posted the DIY WB information to the EEC
list.  I did because someone on that list was about to go buy one for
$1K. The info was posted as a DIY project that could save him some
coin.  It also helped bring the costs down for both lists.  I would be
getting one but I spent the $1k already and have one.  There has been no
talk on that list to make it a commercial project, there were some who
felt that their skills were not up to the building stage and were asking
for help as there is/was on this list.

On this list I am a lurker, have been for over a year, on other lists I
give cause I been there.  You want to know about Corvette LT 5 (ZR1's) I
get you the answer all the way to the engineers who designed the motor.
On that list I contribute.  If I had the expertise to contribute here I
would but I don't so I try to learn what I can.

If you note I try to work back the other way too, see my earlier post
about Tabs and scalars something used by the EEC guys that would make
things easier here.  IE the Tab is a description in english that I can
understand that is a pointer to a memory location in the code that
corresponds to what the code is doing at that point.  Scalars seem to be
the values being changed laid out in a format that can be
exported/imported from an Excell worksheet that has been designed to
recast/change the values over the range using the applicable
pressure/spark/fuel tables.  IE you have a table laid out for a #15
injector and if you go to #24 lb injector it computes the changes by
just inputting the new size.  The table can then be copied right into
the editor.  Maybe that's what you all are doing but it sure is not that
obvious to my gear driven brain.

You want to take the list to some secret society be my guest but
remember there are givers on this list who would not be here if it was
as closed as you are trying to make it.

The open source hardware/software registration is a very good idea and
can easily be incorporated into projects such as this after all that is
what I thought the projects and ideas on this list were all about.

Tyler 'THE LURKER' Townsley
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org