Need recommendations on tools.

[Ludis Langens]

Scott Peitzsch wrote:
> 
> I've got the basics covered (air
> ratchet, impact gun, blow gun, tire inflation gauge) but am still
> looking for a good straight and angle grinder for head/intake porting
> and other deburring tasks.

I've got a cheap ($20 ??) Campbell Hausfeld die grinder that I bought at
Home Depot.  It's worked great for porting/polishing/deburring.  I've
worn out several carbide burrs with it.  It works fine on low air
pressure.  I've sometimes set the air compressor pressure output real
low to get good control of the grinder speed.  I've had only one problem
with it - sometimes it ices up and stops.  It also gets cold after some
heavy duty grinding.

-- 
Ludis Langens                               ludis (at) cruzers (dot) com
Mac, Fiero, & engine controller goodies:  http://www.cruzers.com/~ludis/
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org