eprom carrier eliminator

[Bruce Plecan]

Long lead ZIF or machine socket for a 24 pin prom.
Ends slightly flattened.
Take a R-N prom holder clip out the out board triangle bits.
Plug ZIF or socket from the top, of the RN holder,  and after making sure
the pins are in place a lil crazy glue to hold things together.
Bruce
    Had to come up with a mechanical answer,   too many lil guys where
burning their fingers by picking up the wrong end of the soldering irons...



> I would like any feedback if this is something that would be useful.
> With the demise of GM eprom carriers from Robert Nugent or at least very
> pricey we need a better solution. As Bruce P. mentioned a while back the
> lead spacing on the RN carriers is .550" wide, while a standard 24 pin
> eprom is .600" wide.
> The solution is a small adapter PCB that would be soldered to the ECM in
> place of the RN carrier base and you can then plug the eprom into a eprom
> socket.
> /Marc


----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org