head gaskets

[Romans, Mark]

Hi Bruce:  I am running
pn# 10105117,
Composition Head Gasket
(Cast Iron or Aluminum Head)
This composition head gasket with stainless steel faces is recommended
for stock and mildly modified engines with 4.00" cylinder bores.  Its
compressed
thickness is .028".

I measured my deck height and it's .008, so nice tight quench.
11.1:1 compression.  No problems so far!
Mark
----- Original Message -----
From: "Bruce Plecan" <nacelp at bright.net>
To: <gmecm at diy-efi.org>
Sent: Monday, January 29, 2001 8:20 PM
Subject: Re: head gaskets


>
> Arrgh.
> I ordered 1010s this am.
> But, I really can't complain.
> One thing I'd forgotten is that the car did sit for 2 years when I
couldn't
> drive.
> I've just used so many Felpros, and really have no complaints.
> Bruce
>
>
>
> > Bruce - sounds like you had exactly the same thing happen that I did a
few
> > months ago.  I was using 1010s- recommended by fel-pro for aluminum
> heads -
> > my builder then sold me some 1003's stainless wire, revised cooling
> > restrictions, he said no problem ever with these.  Its been two months
and
> > counting.  I'll let you know how things turn out in a few years.
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org