Odp: ABS computer data stream & ABS inop issues

[Marek]

Hi
In some early models of ABS it was possibile obtain the error codes via
warning lamp (brigde the terminal A & K on ALDL - the warning lamp blinks in
the same manner like engine lamp ).This method I've checked on Bosch ABS
,then I'm not sure if it'll be functional on your car.
cheers
Marek
----- Original Message -----
From: Roger Heflin <rahmrh at cableone.net>
To: <gmecm at diy-efi.org>
Sent: Sunday, July 08, 2001 4:42 PM
Subject: ABS computer data stream & ABS inop issues


> Hello,
>
> I have the data stream definition for the engine computer in my car,
> does anyone have the ABS computer data stream?   Or know how to get it?
>
> My car is specifically a 93 Z28 Camaro, I believe it has a Delco-Moraine
VI
> ABS computer.
>
> On a related question, I burned one of the wheel sensor wires, and have
> replaced them (solder, and a new crimp on plug), but the abs inop light
> comes on some of the time (it also appears to work some of the time).
> I did make sure to twist the replacement wire in a similar manner
> to the original wire, is there anything else special about these
> wires, or other engine wiring in general?
>
> Roger
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>



-- 

Jezdzisz konno?
Ten konkurs jest dla Ciebie! [ http://konkursy.onet.pl/emarket2/ ]

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org