Application Codes

[Shannen Durphey]

Remove (4) 7mm head bolts inside the glovebox.  Pull the sides of the liner in,
then pull the liner out past the glovebox door retaining straps.  ECM is right
there.  Sometimes you'll need to remove the harness conectors before pulling the
ecm out.  But once the ecm's free, you can connect the harness again and set it on
the glovebox door for easy access.

Shannen

ECMnut at aol.com wrote:
> 
> Lyndon (or anyone),
> Where is the ECM located in a 92 full size chebbie C/K truck?
> TIA
> Mike V
> 
> >
> >  You could start with an ANLW or ARJT under the '7747 library. It only
> > takes
> >  30 seconds to pull the ECM out of a truck...I'd start with the correct
> >  calibr...
> >
> >  Lyndon.
> ----------------------------------------------------------------------------
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org