rapid flashing ses

[JTesta1966 at aol.com]

In a message dated 3/20/01 8:52:45 PM Eastern Standard Time, 
slowfatslug at hotmail.com writes:

<< ion in the zif socket..and ecm was 
 unplugged when I installed the chip..re-installed the duplicate I copied and 
 no flashing ses light,  so Im stumped..  Bad checksum? ... winbin does the 
 checksum for you, right?....  or softwa >>

I remember reading in a certain version of winbin you had to save changes 
then come back in and calc checksum. If you like, send me the bin I'll 
checksum it for you (actually, anyone here can do it), or set it to 
experimental (wherever that is in your bin)

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Jim Testa                                            TType86 on #BuickGN
jtesta1966 at aol.com                               buick.fiendish.net:6667
ASE Master Technician              NJ Lic. Motor Vehicle Inspector
L1 Adv Eng Perf Certified       NJ Licensed Emissions repair Tech
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org