2 Bar map sensor and 730 BIN

[Dan Plaskett]

Hi John,

I was wondering if you did any further development on the over 1-bar MAP for
the 730 and 727 puters.  I've been off line for quite a while and am just
getting back into project mode.  Trying to get my 61 vette T-56 six speed
with a 91TPI and Paxton supercharger back on track after the winter hiatus.
If you've done anything else and would be willing to share it you have a
willing disciple here.  Thanks

Dan Plaskett

----- Original Message -----
From: "John S. Gwynne" <jsg at jsgpc.mrcday.com>
To: <gmecm at diy-efi.org>
Sent: Thursday, August 17, 2000 8:28 AM
Subject: Re: 2 Bar map sensor and 730 BIN


>
>
> | I believe somebody here modified the 730bin for use with a 2 bar map
(i.e.
> | supercharged applications).  Any and all info concerning this bin, where
> | it is located, and the modifications surrounding the conversion to the
bin
> | for the 2bar map would be greatly appreciated.
>
>
> yes, it at <ftp://jsgpc.mrcday.com/pub/gmecm/axxc.S_032000> and
> axxc.bin_032000.
>
> It currently only reports MAP over 1-bar for recording through the
> aldl and changes the way BARO is calculated. I was traveling the week
> before last and worked a couple of evenings on incorporating MAP over
> 1-bar into the fuel and spark tables... all in time....
>
> john gwynne
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org