2 bar ECM again/still (HELP)

[Bruce Plecan]

Code sets the software, memcal sets the hardware.
Using a 90-92 FBod memcal for a v8 would be a good one.
Bruce




>
> Sorry if I missed something here, but where do you get a MEMCAL for a
> V-8 '749 if they never put it in a V-8 car?
>
> Scott
> (never loans out CSH, use it too much)
>
>
> ------------------------------
>
> Date: Thu, 29 Mar 2001 23:26:59 -0500
> From: "Bruce Plecan" <nacelp at bright.net>
> Subject: Re: 2 bar ECM again/still (HELP)
>
> > OK, I stink I got it.
>
> Close but not yet
>
> > I can just plug it into the Sy/Ty memcal & play away.
>
> No you need to use a v8 memcal.  If running a v8.
>
> > I can edit the prom (sounds like Terry has an ECM file for My GMEPro)
>
> Yes
>
> > I still though don't understand why I loose the Wastegate or the TCC.
> not
> > tragic though, I am not running the TCC off of the ECM & there are other
> > ways to do the wastegate).
>
> Different cals move the outputs around.  The syty code uses a WG, none of
> the 730s do hence the 730 doesn't have an output for doing that.
> >
> > I seem to recall seeing the something towards the end of the post on the
> TT
> > w/the Van motor, but....
> >
> > TANX MUCHO, I will be bothering you again later I am sure.
> > BW
>
> --------------------------------------------------------------------------
--
> To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org