165->730 conversion, a quick question

[Brendan .]

Make sure that you disconnect your ESC module, and jump the C and E sockets 
on the plug. The ESC module is not needed for the conversion(that is where i 
ran into the same problem).


>From: Ernst den Broeder <edenbroe at cisco.com>
>Reply-To: gmecm at diy-efi.org
>To: gmecm at diy-efi.org
>Subject: 165->730 conversion, a quick question
>Date: Sat, 26 May 2001 17:31:06 -0400
>
>Do I need a new knock sensor (ie, are they different between MAP/MAF)?  The 
>ECM
>is complaining with a code 43.  I measure 100kohms across the sensor, the 
>shop
>manual for a 91 Camaro tells me it should be ~4000ohms.  I know the knock 
>sensor
>works (when I had the system setup for MAF).
>
>Thanks,
>Ernst
>
>
>----------------------------------------------------------------------------
>To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org