PCB's

[John Voth]

Howdy Y'All,

On Sat, 22 Sep 2001, rr wrote:
>
> Well, without going into the low cost of ~$3.15 a board. How would I
> go about releasing artwork? Gerber files? An old version of Orcad was

I would think that Gerber files would do the job quite well. I know that
my boss has done this frequently.

If you read this page, Alberta Printed Circuits mentions that Gerber plus
Drill files suits them just fine.
    http://www.apcircuits.com/html/file_formats.html

I hope I've helped.

Regards,
John

----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org