[Gmecm] SEQUENTIAL INJECTION FOR TPI

[D.Pray]

It should work fine as long as you have a distributor to install the
position sensor.  Our system is configurable for 4, 6, or 8 cylinders.

Dwight Pray, Chief Engineer
BAK Engineering, LLC
www.bakengineering.com
tel:407-324-2907
fax:407-268-4874
When the solution is simple, God is answering. A. Einstein

----- Original Message ----- 
From: "Tomlinson, Brandon B." <Brandon_Tomlinson at baylor.edu>
To: <gmecm at diy-efi.org>
Sent: Tuesday, May 03, 2005 2:02 PM
Subject: RE: [Gmecm] SEQUENTIAL INJECTION FOR TPI


Dwight,

That system looks very interesting.  Could your cam sensor be used in
efi conversions?  I am still looking for a better system for my 83 Regal
T-type.  The hold up has been the distributor. Nice work. Brandon


-----Original Message-----
From: gmecm-bounces at diy-efi.org [mailto:gmecm-bounces at diy-efi.org] On
Behalf Of D.Pray
Sent: Tuesday, May 03, 2005 11:49 AM
To: D.Pray; gmecm at diy-efi.org
Subject: [Gmecm] SEQUENTIAL INJECTION FOR TPI

Our company has developed a sequencer that converts TPI (and other EFI
systems) to sequential fuel injection.  It works with your existing ECM
and
MEMCAL. We will be testing the prototype tomorrow.  The price is
significantly lower than converting to a completely new controller. Is
there
any interest out there?

The system can be viewed at:
http://www.bakengineering.com/page5.html

Dwight Pray, Chief Engineer
BAK Engineering, LLC
www.bakengineering.com
tel:407-324-2907
fax:407-268-4874
When the solution is simple, God is answering. A. Einstein


_______________________________________________
Gmecm mailing list
Gmecm at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/gmecm
_______________________________________________
Gmecm mailing list
Gmecm at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/gmecm